Page 14 av 24
Installation and maintenance Manual Digital CAP
Document no. DC10000877
3.3 Double poles
AKVA groups Wavemaster steel cages have double rail poles.
Required tools:
- 2 pc. 10mm (= 7/16 inch) open end spanner/wrench
Procedure:
1 Read through this entire procedure before commencing this
installation process
2 Release the left and the right bolt in the upper rail and tread
the clamps in to the rail as illustrated below:
3 Re-attach the left and the right bolts
4 Repeat procedures 2 and 3 for the lower rail
5 Bring all belonging parts to the cage edge
6 Place the connection box next to the desired cage pole
7 Place all pipe clamps around the pole, and fasten them
with the M6 bolts by using one wrench on the bolt
and the other on the nut
8 Tighten bolts well to make sure that the connection box
stays in place also during and after larger cage movements
9 Proceed to chapter 3.4 for CAP assembling procedure.