AK-L1-025 - user manual
p. 3
ź
In case of any doubts regarding operation, safety or connection of the product, please contact
the manufacturer or a qualified specialist for this purpose.
ź
All maintenance, adjustment and repair work on the product may only be carried out by a
qualified person in a specialist facility.
Problem
Cause
Solution
The
LED strip or other
device
connected via
power supply does not
work
No mains voltage
ź
Check the mains fuses
ź
Check the correct connection of
the power supply to the energy
grid
The power adapter is
overloaded
ź
Disconnect the power adapter
from energy grid, check the
correctness of the current
parameters
Incorrect connection of
the device
ź
Make sure that the power
supply is correctly connected to
the power grid
ź
Check that the cords are well
embedded in the connectors
There is a suspicion of a
product defect
ź
Stop using and contact the
seller
The LED strip lights
poorly
The power adapter does
not correspond to the
current parameters
ź
Check corresponds of the
power of the LED strip to the
power supply
Removing the most common problems
LED Power Supply
1.
If LED strip doesn’t have attached locking connectors prepare 0.5 mm² cables or special LED
connectors with cables.
2.
Solder cables to LED strip or attach special LED connector on LED strip in the points
intended for this.
4.
WARNING! For larger LED lighting installations, it is recommended to divide the strip into
smaller sections.
5.
The LED strip in RGB version needs RGB controller.
3.
Screw the cables from the LED strip to the LED power supply using the COM (pin 4, 5) and
+ V (pin 6, 7) screw connectors according to the polarity.
Connecting the LED Strip to the Power Supply:
In order to properly match the power supply with the LED strip, multiply the length of the strip
expressed in meters by the power of the tape, and then select the power supply with a margin of
min. 10% to guarantee long and trouble-free system operation, unless the manufacurer of the
LED strip recommends otherwise.
How to choose the LED power supply correctly?
