AK-L2-100 - user manual
p. 2
Safety Precautions
WARNING! Product heats up during operation. To reduce the risk of burns or overheating the power
supply, do not place it in restricted ventilation area. Also, do not allow the working power supply to touch
soft surface such as pillows, blankets or clothing. The power supplies meets the limits on the surface
temperatures available to the user, as defined in the International Standard for Safety of Information
Technology Equipment (IEC 60950).
Connecting LED strips
or other device
whose demanded power is greather than power of the power
supply, can cause battery failure or even damage (burn) of power supply.
An electrostatic discharge occurs when two object touch each other, for example, an electric
charge that occurs when user touch metal door handle after walking on a carpet . Discharging
electrostatic charges from fingers or other electrostatic conductors can damage electronic
components. To avoid damaging the computer, abstain from touching electrical outlets, wires and
electonic circuits. The user’s contact with electronic components should be kept to a minimum.
The II protection class device. It provides protection against electric shock against direct and
indirect contact, and thanks to the additional isolation it is not necessary to connect the device
case with the protective earth conductor.
The device is intended only for domestic use, indoors.
The manufacturer of the product is not responsible for damage or insults caused in effect
of disobey the safety instructions and informations contained in these user manual.
ź
Keep the product and the packaging out of range of children and animals. The package
includes a foil that child could choke while playing.
ź
It is forbidden to apply the mechanical load to the product - strong shocks, impacts, dropping or
crushing may cause its damage.
ź
The product operation in adverse conditions is not allowed. Adverse conditions are primarily:
exposure to direct sunlight, high or very low ambient temperatures, strong vibrations, high
humidity, surrounds of gases, dusts or flammable and aggressive liquids.
ź
If the product has been damaged, does not work properly or has been stored for a long period
of time in bad or unfavorable conditions, safe operation of the device is not possible. It is
essential to stop using the product and to protect it against re-use for security purposes.
ź
Take account of the user manual for other devices connected to the LED power supply.
ź
Product and power cord should not be touched with moist or wet hands under no
circumstances.
ź
Short-circuiting the current connection is prohibited.
ź
It is forbidden to put objects inside the housing.
ź
Make sure that the power cord is not crushed, bent, twisted, rubbed against sharp edges or
mechanically loaded in any other way. Avoid thermal load of the cable - in particular keep away
from heat sources (such as stoves, radiators, fireplaces).
ź
Power cords should be laid in such a way as to eliminate the risk of stumbling or hooking over.
ź
Connection of power supply to electricity is made by connecting it to the AC phase conductor.
ź
Before connecting the power supply to the phase conductor (cable is not included), make sure
that the voltage specified on the power supply matches voltage supplied to the electrical
connection.
ź
Before connecting the power supply / LED stips (or other devices) or conservation of the power
supply make sure that the power cords are not live.
LED Power Supply
