GB
58
Robolinho 700E/700I
Transport
IMPORTANT!
Damage to the appliance
due to incorrect repair
The blade plate can be
damaged by the alignment
of a bent, built-in cutting
blade.
■
Do not align bent cutting
blades.
■
Replace bent cutting
blades by original spare
parts from AL-KO.
Worn or bent cutting blades must be replaced.
1. Switch off the appliance with
.
2. Put down the appliance with the cutting
blades pointing upwards.
3. Unscrew the fastening screws.
4. Take the cutting blade out of the blade seat.
5. Clean the blade seat with a soft brush.
NOTE
The cutting blades are sharpened along
the entire length and can therefore also
be mounted rotated by 180°, which dou-
bles their runtime.
6.
Replacing the cutting blades:
■
If cutting blades have not been rotated
since the initial mounting: Rotate the cut-
ting blades by 180° and insert into the
blade seat again with the sharpened side
pointing towards the appliance, and tight-
en the fastening screws again by hand.
■
If the cutting blades have already been
rotated once since the initial mounting:
Insert new cutting blades into the blade
seat again with the sharpened side point-
ing towards the appliance, and tighten
the new fastening screws by hand.
Note:
It is only allowed to use original
spare parts from AL-KO.
As a rule, the clearer blades do not need to be
replaced.
In case of stubborn dirt that cannot be removed
with a brush, the blade plate must be replaced
because an imbalance can lead to increased
noise levels, greater wear and malfunctions.
10 TRANSPORT
For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1. Stop the appliance with
or the stop but-
ton.
2.
Switch off the appliance with
.
3.
Lift the appliance with both hands on the
housing:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
11 STORAGE
11.1 Storing the automatic lawn mower
The appliance must be stored over winter or
when it is to be taken out of service for an ex-
pected duration of longer than 30 days.
1.
Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable bat-
tery (08)", page 51
).
2.
Thoroughly clean the appliance (see
chapter
).
3.
Store the appliance:
■
upright on all wheels
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.2 Storing the base station
The base station can, but does not have to be put
into storage. Storage prevents premature ageing,
however, such as fading of the colour or corro-
sion of the charging contacts.
If the base station remains outdoors:
1.
Disconnect the power supply from the mains
supply and unplug from the base station.
2.
Roll up the cables of the base station.
3.
Store the power supply.
4.
Grease the charging contacts with contact
grease.
Summary of Contents for 127547
Page 67: ...67...
