GB
64
Robolinho 700E/700I
Help in case of malfunction
Fault code
Cause
Remedy
CN012: Cal: no loop
CN015: Cal: outside
Fault during the calibration:
■
The appliance cannot
find the boundary cable.
■
Check the LEDs on the base sta-
tion.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Place the appliance at the pre-
scribed calibrating position; align
precisely at right angles. Appliance
must be able to drive over the
boundary cable.
CN017: Cal: signal
weak
Fault during the calibration:
■
Loop signal too weak
■
No loop signal
■
The boundary cable is
faulty.
■
Place the appliance at the pre-
scribed calibrating position; align
precisely at right angles.
■
Check the power source of the base
station. Disconnect and reconnect
the power supply.
■
Check the boundary cable for dam-
age.
CN018: Cal: Colli-
sion
Fault during the calibration:
■
The appliance has
bumped into an obstacle.
Remove the obstacle.
CN038: Battery
The rechargeable battery is
flat:
Loop of the boundary cable
is too long, too many islands.
Correct the location of the boundary ca-
ble.
When charging, no contact to
the charging contacts
■
Clean the charging contacts.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Have the charging contacts checked
and replaced by a service centre of
the manufacturer.
Obstacles close to the base
station
Remove the obstacles.
The appliance has got stuck.
Place the appliance on the free, desig-
nated grass surface.
The appliance does not find
the base station.
■
Check the boundary cable for dam-
age.
■
Have the boundary cable repaired
by a service centre of the manufac-
turer.
The rechargeable battery is
depleted.
Have the rechargeable battery replaced
by a service centre of the manufacturer.
The charging electronics are
faulty.
Have the charging electronics checked
by a service centre of the manufacturer.
Summary of Contents for 127547
Page 67: ...67...
