GB
48
Maintenance and care
■
Do not smash the starter battery. The electro-
lyte (sulphuric acid) causes chemical burns to
the skin and clothing – immediately rinse
away with plenty of water.
■
Keep the starter battery clean. Only wipe
clean with a dry cloth. Do not use water, pet-
rol, thinners or similar for this purpose.
■
Keep the connection terminals clean and
grease them with terminal grease.
■
Do not short-circuit the connection terminals.
Charging the starter battery
Charging is required:
■
Before putting into storage before the winter
break.
■
If the machine will not be used for a long time
(longer than 3 months).
WARNING!
Danger if the starter battery is not
charged correctly!
The charging current of the charger must
not exceed 5 A, and the charging voltage
can only be max. 14.4 V. Risk of explo-
sion of the starter battery if the charging
current is more powerful!
Always remove the ignition key before
starting work on the battery.
We recommend charging this maintenance-free,
gas-tight starter battery using a specifically suit-
able charger (which can be obtained through re-
tail outlets).
Comply with the operating instructions of the
charger manufacturer before and during charging
of the starter battery.
CAUTION!
Danger of a short circuit!
To avoid a short circuit, always discon-
nect the negative cable (-) of the battery
first, and reconnect it last!
Always remove the ignition key before
starting work on the battery!
1. Remove the ignition key (05).
2. Open the engine cover.
3. Connect the charger terminals to the connec-
tion terminals of the battery.
NOTE
Check the polarity:
■
Red terminal = positive terminal (+)
■
Black terminal = negative terminal (-)
4. Connect the charger to the mains and switch
it on.
10.5 Removing the mower mechanism
The mower mechanism must be removed in or-
der for the tractor to be used for snow clearing
and for renewing the V-belt.
1. Turn the front wheels (29/1) to the left stop.
2. Remove the grass catcher (30/1).
3. Remove the discharge channel (15/2).
4. Release the cap screw (31/1) on the channel
holder 5-6 turns.
5. Lower the mower mechanism (32/1) to the
lowest setting with the cutting height adjust-
ment lever (32/2).
6. Unhook the tension spring (33/1) on the
mower mechanism.
7. Raise the mower mechanism (34/1) to the
highest setting again with the cutting height
adjustment lever (34/2).
8. Disconnect the V-belt duct (35/1) (35/a).
9. Unhook the V-belt (36/1) from the engine's V-
belt pulley.
10. Lower the mower mechanism (32/1) to the
lowest setting again with the cutting height
adjustment lever (32/2).
11. Remove the locking pins (4 pieces) (38/1)
from the mower mechanism mounting brack-
ets.
12. Pull off the holding clips over the pins (38).
13. Pull out the mower deck on the right side in
the direction of travel.
10.6 Renewing the V-belt
1. Release the locking nuts (6 pieces) (21/1).
2. Disconnect the V-belt duct (22/1).
3. Unhook and remove the right cover (23/1) of
the mower mechanism.
4. Unhook and remove the left cover (24/1) of
the mower mechanism.
5. Slightly release the screw (25/1) on the ten-
sioning pulley (25/2) until the V-belt (25/3)
can be fed out.
6. Remove the V-belt.
Summary of Contents for Comfort 220 I
