GB
38
CS 4030
Operation
12.8 Filling saw chain oil (09)
IMPORTANT! Danger of damaging the
chain saw.
The chain saw will be severely dam-
aged if there is too little or even no saw chain oil
in the tank or if it has dried/is sticky. Dried/sticky
saw chain oil can lead to damage to oil-channel-
ling components and the oil pump. Damage also
occurs if used oil is used. The use of used oil
leads to environmental damage!
■
For start-up work, fill saw chain oil into the
tank.
■
Do not use any used oil!
■
Each time before changing the rechargeable
battery at the latest, fill the tank with saw
chain oil again.
The saw chain and the chain bar are continuous-
ly supplied with oil during operation by means of
an automatic oiler system. The saw chain oil pro-
tects against corrosion and premature wear.
There must always be sufficient saw chain oil in
the tank to lubricate the saw chain sufficiently.
To lubricate the saw chain and the chain bar, on-
ly use environmentally friendly, biodegradable,
high-quality saw chain oil. This oil must be trans-
ported and stored in approved and appropriately
labelled containers.
Each time before starting work or changing the
rechargeable battery, check the oil level and re-
plenish the saw chain oil if necessary:
1. Check the oil level in the viewing aperture of
the tank (09/1). It must always be possible to
see oil. The minimum and the maximum oil
level must not be exceeded.
2. Refill saw chain oil via the filler neck (09/2) if
necessary.
13 OPERATION
DANGER! Danger of fatal injury and dan-
ger of extremely severe injury.
Lack of knowl-
edge of the safety instructions and operating in-
structions can lead to extremely serious and even
fatal injury.
■
Read and follow all safety instructions and in-
structions for use in these operating instruc-
tions as well the operating instructions which
are referred to before you start using the
chain saw.
■
Comply with working time regulations in force
in your country.
■
Grip the rear handle firmly with your right
hand and the bow handle with your left hand,
and hold them tightly.
■
Do not release the handles as long as the
motor is running.
■
Do not use the chain saw if you are:
■
Tired
■
Unwell
■
Under the influence of alcohol, medicines
and drugs
13.1 Determining the charge status of the
rechargeable battery (04)
There is a control panel with a push-button (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
1. Press the push-button (04/1).
The charge status displays light according to
the charge status of the rechargeable battery.
2. Read off the charge status.
Lighting LEDs
Charge status of the re-
chargeable battery
Green (04/2)
The rechargeable battery is
fully charged.
Green (04/3)
and (04/4)
Rechargeable battery is
charged to over 50 %.
Green (04/4)
Rechargeable battery is
charged to less than 50 %.
Red (04/5)
The rechargeable battery is
fully discharged or the re-
chargeable battery has been
overheated/undercooled.
13.2 Check the saw chain oil
Procedure see
chapter 12.8 "Filling saw chain oil
IMPORTANT! Danger of damaging the
chain saw.
The chain saw will be severely dam-
aged if there is too little or even no saw chain oil
in the tank or if it has dried/is sticky. Dried/sticky
saw chain oil can lead to damage to oil-channel-
ling components and the oil pump. Damage also
occurs if used oil is used. The use of used oil
leads to environmental damage!
■
Each time before starting work, check that
enough saw chain oil is present in the tank.
■
If the oil level is low, refill saw chain oil.
■
Do not use any used oil!
Summary of Contents for CS 4030
