1.
72
Robolinho
GB
Maintenance and care
Program Info
Shows current settings such as the total weekly
mowing time.
Failures
Shows the fault messages that last occurred with
date, time and fault code.
9 MAINTENANCE AND CARE
CAUTION! Risk of injury.
Sharp-edged and
moving appliance parts can lead to injury.
■
Always wear protective gloves during
maintenance, care and cleaning work.
9.1
Cleaning
IMPORTANT! Danger from water.
Water in the
automatic lawn mower and in the base station
leads to damage on electrical components.
■
Do not spray the automatic lawn mower and
base station with water.
Clean the automatic lawn mower
CAUTION! Danger of injury due to the
cutting blade.
The cutting blades are very sharp
and can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do not get
into the cutting blade.
Once a week, carry out the following:
1. Switch off the appliance with
.
2. Wipe off the surface of the housing with a
broom, a brush, a damp cloth or a fine
sponge.
3. Brush off the underside, mower deck and
cutting blade with a brush.
4. Check the cutting blade for damage. If
necessary, replace the following: see
chapter
9.3 "Replacing the cutting blades", page 55
.
Cleaning the base station
1. Regularly remove grass residues and leaves
or other objects out of the base station.
2. Wipe off the surface of the base station with a
damp cloth or a fine sponge.
9.2
Regular checks
General checks
1. Once a week, check the whole Installation for
damage:
■
Machine
■
Base station
■
Boundary cable
■
Power supply
2. Replace defective parts by original spare parts
from AL-KO or have them replaced by an AL-
KO service centre.
Check the rollers can move freely
Once
a week, carry out the following:
1. Carefully remove grass residues and soiling
from the areas around the rollers. Use a
broom and cloth for this.
2. Check that the rollers run freely and that they
can be steered.
Note: If the rollers do not move freely or
cannot be steered, have them replaced by an
AL-KO service centre.
Check the contact surfaces on the automatic
lawn mower
1. Use a cloth to remove soiling and then lightly
grease with contact grease.
Check the charging contacts of the base
station
1. Disconnect the mains plug.
2. Press the charging contacts in the direction of
the base station and release them. The
charging contacts must spring back into the
initial position.
Note: If the charging contacts do not spring
back, have them replaced by the AL-KO
service centre.
9.3
Replacing the cutting blades
CAUTION! Danger of injury due to the
cutting blade.
The cutting blades are very sharp
and can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do not get
into the cutting blade.
IMPORTANT! Damage to the appliance due
to incorrect repair.
The blade plate can be
damaged by the alignment of a bent, built-in
cutting blade.
■
Do not align bent cutting blades.
Summary of Contents for Robolinho 1150
