AL-KO SnowLine 620 E III Translation Of The Original Instructions For Use Download

Page: 31 / 316

469370_c

Start-up

4.9

Fitting the snow discharge spout hand
crank (12)

1. Insert the guide for the hand crank (12/1) into

the handlebar and secure. Do not tighten yet.

2. Push the hand crank through the guide in the

handlebar (12/a).
If it is difficult or not possible to move the
hand crank down to the lower guide, it may
be necessary to adjust the guide in the han-
dlebar slightly. In this case, loosen the bolts
slightly, then tighten again after adjustment
(12/1).

3. Insert safety pin (12/2) using the pliers (12/b).

START-UP

WARNING! Danger of injury from faulty

appliance.

Operation of an faulty appliance can

result in serious injury and damage to the appli-
ance.

■

Operate the appliance only when it is undam-
aged and has not defects, and when no parts
are missing or loose.

NOTE

Always perform a visual check prior

to start-up. Do not operate the equipment if the
operating and/or fastening parts are loose, dam-
aged, or worn.

5.1

Operating material

DANGER! Risk of explosion and fire.

escaping petrol/air mixture can cause an explo-
sive atmosphere. Deflagation, explosion and fire
can lead to serious and even fatal injuries if fuel
is not handled properly.

■

Do not smoke when dealing with petrol.

■

Only handle petrol out of doors and never in
enclosed spaces.

DANGER! Risk of poisoning.

The engine

exhaust gases contain carbon monoxide that can
kill a person within a few minutes.

■

Operate the engine only outdoors, never in a
closed room.

■

Do not inhale the engine exhaust gases.

■

Switch off the engine if you feel nauseous,
dizzy or weak during use. Immediately con-
sult a doctor.

NOTE

Dispose of used engine oil in an en-

vironmentally-responsible manner. We recom-
mend dropping off waste oil in a closed container
at a recycling centre or a customer service cen-
tre.

Do not dispose of waste oil

■

in domestic waste

■

in sewers or drains

■

or onto the ground

NOTE

Observe the enclosed operating in-

structions for the engine!

Before starting operation, the engine must be
filled with oil and the snow blower filled with pet-
rol.

Petrol

Engine oil

Grade

Petrol / un-
leaded

(86 Octane or
higher)

The engine
can be operat-
ed with E10
petrol.

Recommen-
dation

SAE 5W-30

Filling amount

4 l

0.95 l

5.2

Filling with engine oil (13)

1. Unscrew the oil filler cap (13/1) and put it

down in a clean place.

2. Pour in oil through a funnel.

3. Check the oil level.

4. Securely tighten and clean the oil filler neck.

Refer to the engine operating instructions for cor-
rect checking of the oil level.

5.3

Filling with petrol (13)

1. Unscrew the tank cap (13/2) and put it down

in a clean place.

2. Pour in petrol through a funnel.

3. Securely tighten and clean the tank filler

neck.

5.4

Checking the tyre pressure (14)

1. Check the tyre pressure particularly before

using for the first time in the winter and at
least every three months during the season.
The maximum permissible tyre pressure is in-
dicated on the tyres (14/1). Note: 1 bar = ap-
prox. 14.5 psi

2. Inflate the tyres uniformly using a tyre pump.