OPERATION
Operation Section 4-12
OPERA
TION
© 2004 Alamo Group Inc.
SRW1400 10/04
WARNING!
When attaching the PTO yoke to the Tractor PTO shaft, it is important that the spring
activated locking collar slides freely and the locking balls are seated securely in the
groove of the PTO shaft. A driveline not attached correctly to the Tractor PTO shaft could
slip off and result in personal injury and damage to the cutter.
7. DRIVELINE ATTACHMENT
6.1 Leveling Windrower
NOTE: The rock windrower must be in working position
before the machine can be leveled. To level the machine
the following procedure is recommended: First find a
level piece of ground or concrete pad to set the machine
on. Insert the 1-3/8" diameter transport pin in the lock
pin hole. Refer to figure
DANGER!
Ensure that no one is near the machine while hydraulics are being
created
.
Lower the windrower drum until the rear wheels are lifted off the ground slightly. Next loosen the bolts holding the
axle plates. Raise or lower the windrower frame until it is level front to back. The tires should be resting evenly on
the ground. Retighten the axle plates.
IMPORTANT:
Periodically re-check the tightness of the axle plate bolts especially before
transporting the machine on public roads.
Remove the transport pin from the lock pin hole and return it to the storage hole on the main frame.
Pivot the divider gearbox shield back, and out of the
way. Remove any tape from the gearbox shafts, and
any booklets from the driveline. Slide the clamp collar
end of the tractor shaft onto the gearbox shaft. Insert
the tapered pin/ bolt into the yoke. Push the yoke until
the groove of the shaft lines up with the hole, and the
pin extends through. Tighten the locknut to squeeze
the yoke onto the shaft.
Connect the universal joint assembly to the tractor
PTO. Align the quick disconnect yoke splines with
the tractor PTO splines. Compress the lock collar
spring and slide the yoke into place. Release the
spring to lock onto the PTO shaft.
Summary of Contents for Schulte SRW 1400
