OPERATION
Operation Section 4-28
OPERA
TION
© 2004 Alamo Group Inc.
SRW1400 10/04
It is critical that driveline clutches slip when an obstacle or heavy load is encountered to avoid implement and
tractor damage. If the implement sits outside for an extended period of time or are exposed to rain and/or
humid air, the clutch lining plates must be inspected to ensure they are not frozen together from rust or
corrosion. If the implement has been exposed to such conditions, at the start of each season, and any time
it is suspected that the slip clutch plates may be frozen together, readjust the slip clutch as explained in the
maintenance section of this manual
DANGER!
Never allow children to play on or around the Tractor and Implement. Children can slip or
fall off the Equipment and be injured or killed. Children can cause the Implement to shift or
fall crushing themselves and others.
(SG-25)
Properly preparing and storing the windrower at the end of the season is critical to maintaining its appearance
and to help ensure years of dependable service. The following are suggested storage procedures:
1.
Thoroughly clean all debris off the implement to
prevent damage from rotting grass and standing
water.
2.
Lubricate all implements points and fill gearbox oil
levels as detailed in the maintenance section.
3.
Tighten all bolts and pins to the recommended
torque.
4.
Check the implement for worn and damaged parts.
Perform repairs and make replacements
immediately so that the implement will be ready
for use at the start of the next season.
5.
Store the implement in a clean, dry place with the
implement frame resting securely on blocks or at
ground level.
6.
Keep the drivelines yokes from sitting in water, dirt
and other contaminants.
7.
Use spray touch-up enamel where necessary to
prevent rust and maintain the appearance of the
implement.
12. WINDROWER STORAGE
Summary of Contents for Schulte SRW 1400
