37
•
Clean the combustion chamber and 2nd transition pipes with a pipe brush.
•
Open the cleaning cover on the back cover and remove any sooting
from the fume cupboard.
•
Check the front cover refractory.
•
Check the sealing elements of the front and rear cover combustion
gases.
•
Reassemble and tighten cleaning cover at the rear cover with care to
the sealing element.
•
Put the turbulators back. All pipes must have a turbulator.
•
Close the front cover. Visually check the cover gas insulating gasket
and refractory.
•
If removed, reassemble the fuel line.
•
Open the fuel line.
•
Carry out a fuel leakage check on the disassembled area (Never use
fire)
•
Switch on the main power supply.
•
You can put the system into operation again (If the fuel line is removed,
the burner may not start in the first 1-2 attempts; it will be activated
when the air in the fuel line is bled).
Call your authorized service at least once a year to have them to control
of the combustion parameters, safety and control devices.
Call your authorized service at least once a year to have them to control of the
combustion parameters, safety and control devices.
When the burner failures, please check the following before calling the authorized
service.
•
Is there required power supply in boiler and burner control panels?
•
Are the fuel valves open?
•
Are the main power switches on the boiler and burner control panel open?
•
Is the boiler water temperature below the temperature at which the
boiler thermostat is set?
•
Is the fuel available within the limits given? (Min. gas pressure or fuel
level in fuel tank)
•
Is the system water level or pressure within normal limits?
•
Did you manually reset the limit temperature stop thermostat?
•
Please do not change the setting of any safety devices.
