background image

LEKTROLOK--MODELS 103 & 104RA 

DEADBOLT ELECTRIC LOCKS 

INSTALLATION INSTRUCTIONS

 

 

345 Bayview Avenue 

Amityville, New York 11701 

For Sales and Repairs 1-800-ALA-LOCK 

For Technical Service 1-800-645-9440 

© ALARM LOCK 2003 

WI1192  4/03 

The LEKTROLOK Models 103 and 104RA Deadbolt Electric 
Locks are compact units designed to fit narrow stile doors.  Both 
models come complete with "keepers" (deadbolt holes) which 
make it simple to install on all types of doors or windows includ-
ing single, pairs, double acting or overhead, either in-swinging or 
out-swinging.  When the lock is aligned with the keeper, the 
deadbolt projects into the keeper thus locking the door.  The 
deadbolt is retracted (and the door unlocked) by means of a re-
mote switch, a key switch, time programmer or other electrical 
contact which interrupts the power.  Both models are ideally 
suited to programmed locking and unlocking of laundromats, 
lobby doors, or other unattended areas.  Use of a lighted push 
button switch at the door (Alarm Lock Model 191) assures that 

people inside the building can exit after Iock-up time; the door 
will relock automatically after exit.  May be wired with smoke 
detectors and/or fire alarm systems for automatic unlocking in a 
fire emergency. 
 

MODELS AVAILABLE 

Model 103 is a standard "fail safe" unit which projects the dead-
bolt only while power is "on".  When the power is off, the dead-
bolt retracts.  Model 104RA ("Reverse Action") unlike the stan-
dard unit is "fail secure" and will project the deadbolt only when 
the power is "off".  When the power is "on", the deadbolt re-
tracts. 

LEKTROLOK--MODEL 103/104RA  

ELECTRIC DEADBOLT 

FLUSH KEEPER 

ANGLED KEEPER 

MORTISE KEEPER.  INSTALLED FLUSH 

(INSIDE THE DOOR FRAME).  FOR USE 

WITH WOOD DOOR FRAMES ONLY. 

Summary of Contents for LEKTROLOK 103

Page 1: ...mer or other electrical contact which interrupts the power Both models are ideally suited to programmed locking and unlocking of laundromats lobby doors or other unattended areas Use of a lighted push button switch at the door Alarm Lock Model 191 assures that people inside the building can exit after Iock up time the door will relock automatically after exit May be wired with smoke detectors and ...

Page 2: ... DIMENSIONS 1 W x 6 L including keeper Bolt diameter is 5 8 and projects 5 8 FINISH Lock and keeper painted aluminum WEIGHT 3 lbs including keepers POWER REQUIREMENTS 600mA 24VAC or VDC 103 12V version available a extra cost LOCKING BOLT Actuated by a continuous duty solenoid LOCK 24 VOLT AC DC TRANSFORMER MODEL 221 NORMALLY OPEN SWITCH ES BLACK RED LOCK 24 VOLT AC DC TRANSFORMER MODEL 221 NORMALL...

Page 3: ... spring refer to the diagram below and replace it as follows 1 Remove the lock cover 2 Remove the screws holding the solenoid to the base 3 Slide the solenoid out of the base 4 Remove the colored spring 7 coils and replace it with the spring not colored 5 coils included in the box 5 Slide the solenoid back into the base 6 Fasten and tighten the screws holding the solenoid to the base 7 Fasten the ...

Page 4: ...FRAME FLUSH KEEPER ATTACHED TO TOP EDGE OF DOOR Mount lock on door frame rather than the door for ease of wiring Examples are shown below INSWINGING HORIZONTAL INSTALLATION DEADBOLT ON FRAME WITH SPACER AND A FLUSH KEEPER SCREWED INTO DOOR SEE BELOW IMAGE SPACER MORTISE KEEPER MAGNET IS MORTISED EMBEDDED INSIDE THE DOOR FRAME AND KEEPER IS INSTALLED FLUSH FOR USE WITH WOOD DOOR FRAMES ONLY METAL F...

Reviews: