Alarm Lock Networx ETPLNRX Programming Instructions Manual Download

Page: 4 / 16

Supported Products

DB9 to DB9 Serial Cable

Enroll ProxCards into the AL-PRE, then transfer this ProxCard

data from the AL-PRE to the computer via

this 9-pin DB9 to DB9 serial cable.

Proximity Card Reader/Enroller

(AL-PRE)

AL-PRE

is used to quickly enroll multiple ProxCards

and ProxKey

keyfobs into DL-Windows. Use

the supplied 9-pin DB9 to DB9 serial cable to connect the AL-PRE to your computer’s serial COM port.
Compatible with most HID ProxCards

and ProxKey

keyfobs (37 bits or less). For PDL and PL series

locks only.

ProxCard

/ ProxKey

Keyfob

Compatible with most HID ProxCards

and ProxKey

keyfobs (37 bits or less).

Note:

ProxCard

and ProxKey

are trademarks of the HID

Corporation.

H I D

HID CORPORATION

PROX-

CARD

H I D

PROX

KEY

DL-Windows Software Application

Alarm Lock Trilogy Microsoft Windows-based software application, v5.0.0 or higher, supports Trilogy Net-
worx and Trilogy Standalone Locks, with single database.

Free of charge

and downloadable online at

www.alarmlock.com.

DL-Windows software is the basis for the wireless lock programming inter-

face.

For those unfamiliar with using DL-Windows software, stop here and review the DL-Windows User

Guide (OI237) and the Wireless Network Setup & DL-Windows Configuration Instructions, (OI352).

Supported Products

AL-IM80211

AL-IME

AL-IMEPOE

AL-IMEPOEP

AL-IM SERIES WI-FI Gateway Module

The PL6600 and ETPLNRX each contains a radio that transmits and receives data--via a private wireless
signal--to an intermediate device called a Gateway module. In turn, this Interface Module is connected
(either wirelessly or wired) to a computer network such as a LAN or corporate Intranet. A Windows PC
connected to this network can control and program all PL6600 / ETPLNRX locks by the use of the

DL-

Window

software (see OI237 and OI352). With access rights to the software, one computer--or several--

can control the software and consequently can control the devices in the system. Several Gateway device
models are available:

•

"Wireless/Wired" AL-IM80211

Hardwired/Wireless Gateway Interface Module. Supplied with its own

class 2 transformer to supply power and supports connection to a network either using 802.11 or a
standard Ethernet cable. This "Wireless/Wired" Gateway module has two antennas, one for the
proprietary radio connection to the PL6600 / ETPLNRX and the other for 802.11 network
transmissions. Ensure adequate 802.11 coverage in the area where the "Wireless/Wired" Gateway is
mounted. Supports up to 63 Networx Locks. Ceiling- or wall-mountable.

•

"Wired" AL-IME

Hardwired Gateway Interface Module, supports up to 63 Networx Locks, connects

directly to a network using a standard RJ-45 Ethernet cable. This model has one antenna used to
transmit to the PL6600 / ETPLNRX via an Alarm Lock proprietary radio connection.. Ceiling- or wall-
mountable. Powered with Class 2, 6VAC transformer (supplied).

•

"Power over Ethernet" AL-IMEPOE

Hardwired Gateway Interface POE (Power Over

Ethernet), supports up to 63 Networx Locks, connects directly to a network using a standard RJ-45
Ethernet cable and POE. This model has one antenna used to transmit to the PL6600 / ETPLNRX via
an Alarm Lock proprietary radio connection. Ceiling- or wall-mountable.

•

Gateway "Plenum Rated POE" AL-IMEPOEP

- Same as above "

AL-IMEPOE

", with added enclosure

protections and installation hardware for mounting above "drop-ceiling" tiles or other locations subject
to air pressure changes (HVAC air-filled spaces, etc.).