Alarm Lock Networx ETPLNRX, Programming Instructions Manual

9 

Erase All Programming 

Restore the "out of box" factory condition. 

1.     At the back of the lock, remove the screw at the bottom of the lock housing and remove the cover.   
2.     Disconnect the battery pack connector. 
3.    With battery power disconnected, short the two white wires (

Remote Input 

wires) together for 10 seconds to 

ensure discharge of all capacitors.  After 10 seconds, remove the short.   

4.    Re-connect the battery pack.  The lock will immediately sound 3 short beeps (if these 3 beeps are not heard, 

then restart at step 3).  Within 3 seconds, hold down the outside handle. 

5.    The lock will then sound more slow beeps, 1 beep for every second it takes to clear the memory.  Release the 

handle. 

6.    Lock is ready for programming after 2 rapid beeps are heard and 2 green LED flashes are seen. 

Verifying Proximity Card and Keyfob Access

Test by simply presenting a valid proximity card or fob to the reader in front of the lock. 

VALID CARD - 

Green LED flashes, the sounder beeps several times and the PL6600/ETPLNRX unlocks.   

INVALID CARD -

 Red LED flashes several times and the sounder beeps several times.   

Testing the Cards Entered 

Use when re-applying power to a lock already in use (you wish to retain the Lock Program), such as when moving 
an existing lock to a new door.  The lock must be dismantled and powered down for an extended period. 
 

1. Disconnect battery pack connector. 
2. With battery power disconnected, short the two white wires (

Remote Input 

wires) together for 10 seconds to 

ensure discharge of all capacitors. 

3.

Without touching or turning the handle

, re-connect the battery pack (lock will sound 3 short beeps).  If 

these 3 beeps are not heard, then restart at step 1.  The lock will perform several self tests; when complete, 7 
beeps and LED flashes will sound.  The lock is now ready for use. 

Power Up--Retain Existing Programming 

ACTIVITY 

LED 

SOUNDER 

COMMENTS 

Access Granted or  

Remote Release 

2 green flashes 

2 Beeps 

Invalid Card / Fob 

7 red flashes 

7 Beeps 

An invalid proximity card / fob does not exist in the Lock 
Program memory. 

Valid but Disabled  

Card / Fob 

1 green, 4 red flashes 

1 Long, 5 Short Beeps 

A proximity card / fob exists in the firmware, but is disabled. 

Emergency Commands 

are in effect  

1 red flash every two 

seconds 

-- 

-- 

Low Battery 

See page 8 ("Battery Replacement) before changing  

batteries.  ("Pass Time" is the duration the lock remains 

unlocked after access is granted). 

Red LED and Sounder turn on steady for the  

duration of the "Pass Time". 

Door Ajar  

1 red flash once every 

second (continues for xx 

seconds) 

-- 

-- 

Forced Door Detection 

(door "kick-in")  

-- 

Steady tone  

for xx seconds 

-- 

LED and Sounder Indicators 

With a fully charged battery, the LED and sounder provide visual and audible feedback as follows: