12
tures to customize your system.
Example #1:
DL-Windows by default enables (checks) all of the features, as shown above in the
Features
dialog.
What will happen when all features are enabled and an "
Emergency Lockdown
" command is initiated at the keypad?
Because the
Activate Local Emergency
commands are enabled, the lock that initiates the Emergency Command will
lock, then this lock will inform the Gateway to broadcast the Emergency Command to all locks assigned to the same
"
Gateway Group
".
Example #2:
This example is known as the "pull station option" , where one of the
Activate Global Emergen-
cy
commands is checked, none of the
Activating Local Emergency
commands are checked, and the "
Lock
Responds to Global Emergency Commands
" is unchecked. If an "
Emergency Lockdown
" command is initi-
ated at a lock keypad, the lock will first inform the Gateway to broadcast the Emergency Command to all locks as-
signed to the same "
Gateway Group
", then the lock will ignore the broadcast when received.
Emergency Users
Activating Emergency Commands
By default, Administrative Users (Users 1 through 11) automatically have the ability to initiate Emergency Commands
from the keypad. In addition, "Basic Users" (Users 12+) may be granted the ability to initiate Emergency Commands
from the keypad by adding them as Emergency Users in DL-Windows (for more information about adding Emergency
Users in DL-Windows, see OI383).
Note:
All paired Wireless Remote Releases have the ability to initiate Emergen-
cy Commands (see page 13 for more information).
Access During an Emergency
When enabled:
If the feature
Users are Disabled During Lockdown
is enabled (checked) for a specific
lock, and when the Networx system is in an Emergency Lockdown state, "Basic Users" (Users 12+) are denied
the ability to unlock the physical lock (User Codes / proximity credentials for these Basic Users are ignored).
The User Codes / proximity credentials added to Administrative Users (Users 1 through 11) as well as all
"Emergency Users"
remain enabled
, retaining the ability to unlock a secured lock.
When disabled:
If the feature
Users are Disabled During Lockdown
is disabled (unchecked) for a spe-
cific lock, and when the Networx system is in an Emergency Lockdown state, ANY valid User Code or proximi-
ty credential that exists in the lock's internal memory will be allowed to unlock the secured lock, regardless of
User Number.
Emergency Alert Options
Sounder
If
Enable Sounder on Emergency
is enabled (checked), upon receiving an Emergency Command, the integral sound-
er will beep once per second for 30 seconds.
Emergency Indicator
When
the
feature
Enable Inside Emergency Indicator
is enabled (checked), upon receiving the Emergency Com-
mand, the lightbar (located on the inside housing) flashes a red LED once per second for the duration of the Emer-
gency. For locks equipped without the lightbar, the internal relay will activate once per second.
Tip:
Only " Local" Emergency Commands are supported when using an
AL-IME-USB
Gateway . See page 4
for Gateway model descriptions.
Emergency Commands (cont'd)
When a User Code from an Administrative or Emergency User is pressed at any lock keypad, first the
lock unlocks, then the lock permits the use of the following Emergency Commands:
...press
911
to issue "
Emergency Lockdown
"
...press
000
to issue "
Emergency Passage
"
...press
123
to issue "
Return to Normal
"
[ _ _ _ _ ]
Administrative
or
Emergency User
Code