13
Overview
Two types of "Wireless Remote Release" devices are compatible with the PDL6200 and PDL8200:
The RR-1BUTTON
Wireless Remote Release Button
(see WI1999) and RR-4BKEYFOB
Wireless Re-
mote Release Keyfob
(see WI2004). Whether the Wireless Remote Release contains a single button
(RR-1BUTTON) or four buttons (RR-4BKEYFOB), each button can be "paired" (connected) with one
lock. This means, for example, the four buttons on the RR-4BKEYFOB can each be paired with four
separate PDL8200 series locks. In addition, each individual lock contains ten (10) "slots" ("User Num-
bers"), and each "slot" is available to accommodate one paired Wireless Remote Release button.
Therefore, each individual door lock can ultimately be paired with up to ten Wireless Remote Release
buttons on multiple Wireless Remote Release devices.
Note:
Since each button can ONLY be paired with one specific lock at a time, when a previous-
ly paired button is later paired with a second lock, the first pairing is erased.
Before you "pair" (connect) your Wireless Remote Release buttons, be sure to consider the following:
Wireless Remote Releases can be paired before a lock is enrolled into a Networx system. However, to allow
for lock discovery, the lock must be defaulted and re-initialized (see
ERASE ALL PROGRAMMING
on page
14),
clearing all previously programmed Users and/or paired Wireless Remote Releases
.
Pairing Wireless Remote Release Buttons
Refer to the programming instructions included with the model RR-1BUTTON
Wireless Remote Release Button
(see WI1999) and/or the model RR-4BKEYFOB
Wireless Remote Release Keyfob
(see WI2004).
Emergency Lockdown (via Wireless Remote Release)
The PDL6200 and PDL8200 locks have the added ability to accept Emergency Lockdown commands from a Wire-
less Remote Release (model RR-4BKEYFOB only). Using the RR-4BKEYFOB, when buttons 3 and 4 are
pressed simultaneously, within seconds an Emergency Lockdown command is sent to all locks to which the RR-
4BKEYFOB is currently paired (up to 4). Conversely, pressing buttons 1 and 2 sim-
ultaneously will send a Return to Normal command, returning the paired locks back
to the state they were in prior to receiving the Emergency Lockdown command.
See page 11 for the two different modes (see the section
"Global" vs. "Local"
) to
which the lock will respond when an Emergency Command when sent from a Wire-
less Remote Release.
Wireless Remote Releases
RR-4BKEYFOB
RR-1BUTTON
RR-4BKEYFOB
