Beacon Power Supply Installation Instructions
2.8.2012
52-296 Rev B05
Page 10 of 27
AlarmSaf
65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com
3.3.3 AC Input Safety Precautions
1. CAUTION:
Verify that the main AC power is not energized prior to connecting the BNx000
.
2. CAUTION:
Verify VAC Select jumper (J5) is set properly on the power supply for either 120
VAC or 240 VAC input prior to connecting the cable and energizing the power supply or
damage to the system or personal property and/or injury will occur
.
3. CAUTION:
The Green or Green/Yellow earth ground wire should always be connected first
or disconnected last for safety.
4. The AC input connector is a convenient and safe means for AC disconnect as the connector
is fully shrouded when disconnected.
5. All wiring should be installed in accordance with NEC760, NFPA70, NFPA72, and all local
code requirements. See section 4.2 for more information.
3.4 Accessory Board Connector (P2)
3.4.1 General Information
The Accessory Board Connector (ABC) supplies the output voltage and FAI control to compatible
accessory boards for increased functionality including additional voltage(s), power distribution
and/or power management and control for access control and fire applications. See page 26 for
a list of available accessory modules. For more detailed information on the ABC expansion port,
see Appendix B, “About the Accessory Board Connector”.
3.4.2 ABC Cable Types
Order #
Model #
Description
Used With/Notes
00519
ABC-01
6 PIN – 6 PIN, 8”
1. Used with BNx000 Power Supply, REV AO2 or earlier
2. Used to interconnect EDB-10 & LDB-8 accessory boards in
certain proprietary systems
00520
ABC-02
6 PIN – 6 PIN, 18”
1. Used with BNx000 Power Supply, REV AO2 or earlier
2. Used to interconnect EDB-10 & LDB-8 accessory boards
3. Increased length for connection over longer distance
00521
ABC-03
8 PIN – 8 PIN, 8”
1. Used with BNx000 Power Supply, REV A03A or later for
connection to PD8(F), MB8(F) & CMB8(F) accessory modules
00522
ABC-04
8 PIN – 8 PIN, 18”
1. Used with BNx000 Power Supply, REV A03A or later for
connection to PD8(F), MB8(F) & CMB8(F) accessory modules
2. Increased length for connection over longer distance
00523
ABC-05
8 PIN – 6 PIN, 8”
1. Used with Bx000 Power Supply, REV A03A or later for
connection to SPS4, EDB-10 & LDB-8 accessory modules
00524
ABC-06
8 PIN – 6 PIN, 18”
1. Used with Bx000 Power Supply, REV A03A or later for
connection to SPS4, EDB-10 & LDB-8 accessory modules
2. Increased length for connection over longer distance
CAUTION: The ABC-01 and ABC-02 cables are used on older BNx000 boards (PCB#: 38-118 REV
A02 or earlier) that have a 6-pin ABC connector.
DO NOT USE
these cables on newer BNx000
boards (PCB # 38-118 REV A03A or later) that have an 8-pin ABC connector or damage to the
system could occur.
