13
7
.
It should look like the one pictured above.
8
.
Using pliers, straighten the bend to the left.
10
.
Grip the paperclip at the loop, bending
the loop 90º away from you.
11
.
Your clip should look identical to the
picture above when placed on a table
(Not reversed).
12
.
Peel off the protective coating from part
No.29 for better adhesive quality.
13
.
Use the pin to clear out the holes if
obstructed.
14
.
(A) Cut the second piece of foam square
in half. (B) Hold part No.29 facing towards you
with the larger holes on the left. (C) Stick the
foam to the back side of part No.29.
15
.
Pierce the straight end of the paperclip
through the larger hole closest to center.
Make sure the clip goes through the foam as
well.
9
.
The paperclip should look similar to the
one pictured above.
Summary of Contents for Transitional Species Blubber Bot
Page 2: ......
