10. Redundancy of BCUs, CSUs, and MSUs
280
inactivate standby
Inactivates an active standby system.
By executing this command, you can replace a standby BCU for AX6700S, a standby CSU for
AX6600S, or a standby MSU for AX6300S without turning off the power.
Syntax
inactivate [-f] standby
Input mode
User mode and administrator mode
Parameters
-f
If this parameter is specified, this command is executed without displaying a confirmation
message.
Operation when this parameter is omitted:
A confirmation message is displayed.
Example
1.
The following shows an example of inactivating a standby system.
inactivate standby
2.
A confirmation message appears.
inactivate standby system OK? (y/n):
If you enter
y
, the standby system is inactivated.
Display items
None
Impact on communication
None
Response messages
Table 10-1:
List of response messages for the inactivate standby command
Notes
1.
To restore a standby system that has been changed to
inactive
by this command to
active
,
use the
activate standby
command.
Message
Description
Can't accept command (system is busy).
The command cannot be accepted (because the system is busy).
Re-execute the command later.
Can't execute this command in standby system.
This command cannot be executed on a standby system.
Can't execute.
The command could not be executed. Re-execute the command.
Standby system is already inactive.
The standby system has already been inactivated.
Standby system is notconnect.
The standby system is not installed.
Summary of Contents for AX6300S series
