ATS9462 User Manual
13
Installing the ATS9462
There are four main steps involved in installation:
1. Physically install the digitizer(s) and SyncBoard, if
any, in your computer
2. Install ATS9462 software driver, when prompted by
the operating system
3. Install AlazarDSO software that allows you to setup
the hardware, acquire signals and view and archive
them
4. Optionally, install the ATS-SDK software
development kit or ATS-VI LabVIEW VI or ATS-Linux
Linux drivers, which enable you to programmatically
control the ATS9462
The following paragraphs will guide you through this process
in a step-by-step manner.