Alba Crew, Manual

11

10

3.3 CHECKS AND VERIFICATIONS

Checks must be carried out as indicated in the Maintenance 
chapter (page 32)

of this manual.

If worn or faulty parts are not replaced promptly, the 
Manufacturer accepts no responsibility for any accidental 
damage that may result. Inspections must be carried out by an 
expert; they must be visual and functional in order to guarantee 
the vehicle's safety.

They shall include the following:
• Checking all the load-bearing structures, which must not 

show any breakage, damage, deformation, corrosion, wear or 
alteration with respect to the original characteristics;

•  Inspection of all mechanical parts;
•  Inspection of all safety devices installed on the vehicle;
•  Check all pin and bolt connections;
•  Functional check of the vehicle;
•  Check the condition of the vehicle.
The results of this check must be recorded on a special form.

IMPORTANT! If anomalies are detected, they must be 

rectified before the vehicle is put back into service, 

and the expert carrying out the check must note on 

the card that the repair has been carried out, thus giving 

approval for the vehicle to be used.

In the event of a breakage or dangerous anomaly, the service 
department must be notified immediately.

Take the vehicle out of service if there is a malfunction and 
contact the service department immediately.  

Make sure that there are no objects between the vehicle parts.

Make sure that no objects remain between the moving parts 
after any maintenance work.

WARNING! In order to guarantee maximum safety 

when handling the vehicle, it is in any case 

PROHIBITED to:

•  tamper with any part of the vehicle;

•  leave moving parts unattended;

• use the vehicle in working order but not in complete 

efficiency;

•  modify the vehicle in order to change its originally intended 

use, without explicit authorisation from the Manufacturer 

or without assuming full responsibility as required by the 

Machinery Directive 2006/42/EC;

•  move moving parts by means of manual operations if there 

is no power supply.