Albalá Ingenieros AAD3014C01, Manual

Albalá Ingenieros | Manual 

AAD3014C01

3. INSTALLATION

THE AAD3014C01 MODULE CONTAINS ELECTRONIC DEVICES SENSITIVE TO
ELECTROSTATIC DISCHARGE. Always use antistatic bags clearly identified
with a high degree of shielding for storage and transportation.

The AAD3014C01 module is composed of two parts: one AAD3014P01 main board and
one XAD3000P02 rear board. Both parts must be installed in a UR3000 or UR3100
mounting frame following the instructions in the corresponding section of this chapter.

3.1. Initial inspection

Verify that the package has been properly handled during transport. After opening the
packaging, check that one AAD3014P01 main board and one XAD3000P02 rear board are
inside.

You must notify your Albalá Ingenieros distributor or dealer of any damage or defects
observed.

Follow the instructions in this manual to install this module in the mounting frame.

3.2. Safety instructions

• This equipment must be connected to a mains outlet with a protective

earth connection. Never use extension cords that do not have protective
earthing connection. The lack of an effective electrical connection between
the ground pin in the mains input connector of the equipment and the
protective earth of the electrical power distribution can cause serious harm.

• All modules of the Albalá Ingenieros TL3000 terminal line can be

hot-plugged or unplugged without suffering any damage or affecting the
processes that are currently taking place in other modules in the same
mounting frame. When a module is installed in an empty bay of a mounting
frame, it is necessary to mount the rear board that is part of that module.

Prior to installing this board, the mounting frame must be disconnected
from the power supply network.

 This is required because in addition to the

risk of electrocution for the person handling the device it is possible that a
high instantaneous current coming from the power supply could damage
the connectors and components of the mounting frame and/or the rear
board.

11