Albalá Ingenieros AAD3014C01, Manual

Albalá Ingenieros | Manual 

AAD3014C01

• The AAD3014C01 module and the mounting frame should always be

installed, maintained, operated and removed by personnel with sufficient
technical qualifications. The equipment should never be placed in damp
areas, near splashing liquid, or in explosive or corrosive atmospheres.
Neither modules nor mounting frames can be used in applications that
could endanger human life.

3.3. Environmental considerations

This symbol indicates that this equipment must be deposited at a collection
point for proper waste treatment once it has reached the end of its useful
life.

3.4. Power considerations

The power supplies in the mounting frames of the TL3000 family have been designed to
supply 6 W/slot. The power consumption of the majority of the TL3000 family of
modules is less than 6 W under all conditions, therefore each mounting frame can house
as many modules as it has slots.

Under normal circumstances (with music or vocal signals with levels of 4dBu) the power
consumption of the AAD3014C01 is less than 6W and therefore up to 12 modules can be
installed in a UR3000 mounting frame or up to three modules in a UR3100.

If the AAD3014C01 is used to distribute signals with a higher average level and the
outputs are loaded with 600Ω then the power consumption of the module can exceed
the 6 W reserved per slot. In such cases the total number of AAD3014C01 modules that
can be installed in a mounting frame is lower than the number of available slots.

Use the following expression to calculate the actual power consumption of the
AAD3014C01 and to determine how many modules can be installed in a given mounting
frame without exceeding the capabilities of its power supply:

Power Consumption = 6.5W + (P output (W)/0.6) * Number of Outputs Used

3.5. Installing the module in the mounting frame

The steps needed to install the AAD3014C01 module with the rear board in the
mounting frame are:

1 - Disconnect all power cords from the power supplies of the mounting frame.

2 - Remove the blank panels covering the front and rear of the empty bays chosen for

installing the AAD3014C01 in the mounting frame.

3 - Install the XAD3000P02 rear board ensuring that its 12-pin connectors are properly

12