Albany R-BAC UltraSmart, Manual

15 

Instructions for adjusting defrost heat cycle time 

1.

Press and hold the 

Reset/Menu

 button

 for 3-5 seconds. 

2.

The display will read 

LIMIT SETUP

. Press the 

UP ARROW 

 button until 

the display reads 

MODULE CONFIGURATION

. Press the 

ENTER

 button.

3.

The display will read 

MOD A SAFETY

. Press the 

DOWN ARROW

 button 

until the display reads 

MOD H DEFROST

. Press the 

ENTER

 button 2 

times.

4.

The display will read 

DEFROST INHIBIT

. Press the 

UP ARROW

 button 

until the display reads 

DEFROST HEATER

. Press the 

ENTER

 button 3 

times.

5.

You want the word that the cursor is blinking underneath to be 

CYCLE

. Press the 

UP ARROW

button until you get to 

CYCLE

. Press the 

ENTER 

button.

6.

Press the 

RESET

button until the display reads 

MODULE 

CONFIGURATION

.

7.

Press the 

UP ARROW

 button until the display reads 

SET TIMERS

. Press 

the 

ENTER

 button.

8.

The display will read 

OPEN RUN TIMER

. Press the 

DOWN ARROW 

button until the display reads 

DEFROST CYCLE ON.

 Press the 

ENTER

button.

9.

The cursor will be flashing on the number in the lower RH corner of the display. 
This is the time in minutes that the defrost heat will stay on. Pressing the 

UP 

ARROW 

 and 

DOWN ARROW 

 buttons will change the time. Press 

the 

ENTER  

button once the desired time is reached.