Part N
umber
6410T0006
Version 4/23/2010
17
NOTE:
REFERENCE FIGURE 12 WHILE PERFORMING THE NEXT 7 STEPS. INSTALL CABLES
AND SPRINGS ONE SIDE AT A TIME.
F.
Thread the cable through the intermediate pulley bracket clamped to the side frame. Pull all of the
cable slack through.
G.
Thread the cable over the top pulley from
back to front
. Pull all of the cable slack through.
H.
Thread the cable under the bottom pulley from
back to front
. Pull all of the cable slack through.
I.
Pull the cable taught up to the cable clamp block on the appropriate side of the bottom beam. Mark
the cable at this point where it matches up with the cable clamp block. (
Figure 13
)
J.
Remove the #10-24 bolt holding the cable clamp in the block. Thread the cable up through the middle
hole of the cable clamp until the mark on the cable is above the clamp. Feed the end of the cable back
FIGURE 12
Summary of Contents for RAPID-ROLL 570
