Part N
umber
6410T0006
Version 4/23/2010
29
1.
Mount the chain drive bracket to the side frame using the (4) 3/8-16 nuts and existing studs on axle
bearing bracket.
2.
Attach the chain sprocket, 28mm diameter bore, to the stub axle and tighten set screw.
3.
Mount the drive unit to the chain drive bracket using the (4) M16 x 30mm hex head bolts. Ensure
chain tensioner bracket (“L” bracket) is in between gear reducer and chain drive bracket.
4.
Attach the other chain sprocket to the output shaft of the gearbox and tighten setscrew.
5.
Attach the chain around both chain sprockets and connect the two ends of the chain together using the
chain connection link.
6.
Loosen slightly M16 x 30mm bolts. Apply tension to the chain by turning the center bolt (on the
chain tensioner, 3/8 -16 x 2.5” hex head bolt) clockwise until chain is tightened. Tighten locknut on
bolt. Re-tighten M16 x 30mm bolts.
7.
Attach the chain bracket cover to the other side of the chain bracket.
Summary of Contents for RAPID-ROLL 570
