Part N
umber
6410T0006
Version 4/23/2010
34
FULL ROLL COVER & MOTOR COVER INSTALLATION
NOTE
REFERENCE FIGURE 33 WHILE PERFORMING THIS PROCEDURE
1.
Attach full roll cover mounting brackets to the axle bearing brackets.
2.
Lift the cover into place in front of the mounting brackets.
3.
Align the pre-tapped holes in mounting brackets and secure cover using the six supplied #14 x ½”
screws.
4.
Attach and secure the end plates to the full roll cover using the ten supplied #8 x 5/8” hex head
screws.
5.
Attach motor cover to full roll cover (open side up). The flap on the motor cover will attach to the
backside of the full roll cover.
6.
Secure bottom of motor cover to wall using supplied “L” bracket.
FIGURE 33
Summary of Contents for RAPID-ROLL 570
