Part N
umber
6410T0006
Version 4/23/2010
36
Pull the bottom hinge pin out of the clips (
Figure 35
). In order to prevent damage to these parts, support
the bottom door panel and bottom beam during this step. This will prevent them from dropping to the
floor.
Pull the top hinge pin out of clips. This will allow the removal of the “old” existing Full Vision Panel™.
INSTALL REPLACEMENT FULL VISION PANEL™
Thread the hinge pin between the clips on the bottom door panel and the Full Vision Panel™
(Figure 35
)
Lay both pieces on a clean, level surface and align the clips.
NOTE
ENSURE TO INSTALL THE VELCRO STRIPS ON THE FULL VISION PANEL™ ON THE
SAME SIDE AS THE VELCRO FOR THE BOTTOM DOOR PANEL. WHEN INSTALLED THE
VELCRO STRIPS SHOULD BE ON THE FRONT SIDE OF THE DOOR PANEL.
FIGURE 35
Summary of Contents for RAPID-ROLL 570
