Part N
umber
6410T0006
Version 4/23/2010
45
ride securely on both sprockets by removing links as necessary. Secure the chain by joining the end links
together.
Thread the hand chain through the chain guide holes and over the pocket wheel. Secure the chain by
joining the end links together.
Mount disengagement lever approximately five feet above the floor. Thread steel cable (supplied)
through hole in engage coupling lever (located on hoist housing). Run cable through end of spring
attachment (on disengagement lever) and secure using cable clamp (supplied). To engage the manual
hoist, the lever should be in the down position.
Wire electrical interlock switch as indicated by the electrical schematics provided with the door. This
switch will wire in place where a “crank switch” is indicated on the drawings. If adding a manual hoist
with disconnect to a previously installed door, ensure jumper clip (from factory) is removed from the
terminals where the interlock switch is going to be connected.
Summary of Contents for RAPID-ROLL 570
