Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page
15
3.3
Switching on the power
Close the circuit-
breaker on the home power supply panel. The heating element and the circulating/filtration pump will
start up immediately.
Priming of pumps:
Prime the pumps before using the spas:
-
It is advisable to first remove the filter cartridges from the skimmer in order to facilitate the priming operation.
-
Loosen the bleed cock located on the pump suction (horizontal pipe) in order to discharge the air until water starts
running out of it.
-
Tighten up the coupling and start the pump. The pump should prime and air escapes for a moment through the
massage nozzles.
-
Should the pump not prime quickly, stop it and restart the operation.
Depending upon the model, the control panel may have one or two pumps. Prime each pump in the same way.
Put the filtration cartridges back in place once the pumps have been primed.
Activation of massage pumps (number of massage pumps depending upon the models):
PARES
Press the « JETS 1 » key on the electronic control panel once in order to start pump #1.
MARAMI
Press the « JETS 1 » key on the electronic control panel once in order to start pump #1.
Press the « JETS 2 » key on the electronic control panel once in order to start pump #2.
Test to see that all the functions are in working order;
see page Operation of the spa
