Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page 23
Then press the « Jets » button(s) several times and make sure that all the pumps have indeed been primed (discharge of air).
PARES
1 : Press Jets 1 button to ensure priming has taken place
MARAMI
1 : Press Jets 1 button then Jets 2 button to ensure
priming has taken place
Temperature check (15°C – 40°C)
The water temperature displayed is always the last temperature measured.
In order to display the temperature, press once on the buttons
+
or -. To change the temperature all you have to do is to
press again on the keys
+
or -.
After 5 seconds, the display will return to normal provided no key is pressed.
The setting of the thermostat to its maximum temperature will not speed up the rise in temperature. The temperature rise
should be 1°C per m
3
/h
Advice: it is preferable in the interests of energy saving to maintain a constant water temperature in order to limit the occurrence
of big temperature fluctuations which result in an increase in electricity consumption.
1 : Press to display the temperature
2 : Press again to change the temperature
Temperature display symbol
