Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page
25
Filter function
The Filtr. key enables you to programme your filtration time. To do that, press the Filtr. key then set the time by pressing the
+ or – key on the keyboard. Setting is done on the basis of a number of hours with a maximum of 12h.
e .g. if you opt for Fd 2 your filtration will operate 2h every 12h.
Accelerated Filtration Function
This function enables you to activate the accelerated filtration procedure for a limited time. All the pumps start up as well as
the ozonator for 45 min. To activate this function all you have to do is to press on the
Jets 1
button for 5 sec.
Eco Function
The
Eco
function enables you to save energy by maintaining the temperature of the water 10°C below the programmed
value. In all cases the minimum temperature permitted is 15°C.
To start the
Eco
function all you have to do is press the
Eco
key on the keyboard.
The default value Ed 10 will appear which corresponds to a 10h duration of the function.
It is possible to set the function between 0h and 24h (in intervals of one hour). To do that all you have to is press the + or -
key during the display of the function and press a second time on the
Eco
key in order to confirm the function.
Start timing programmation Filtr. and Eco functions
It is also possible to adjust the start time of your filtration and your Eco mode. To do this, press once on the Filter button or
Eco. (depending on whether you want to set the time of programming or filter your eco mode) then a second time. You will
see the time display flashes. Therefore set the time using the + and - keys on the keyboard. To set the minute press again on
the Filter button. or Eco then adjust using the + and -. Finally confirm by pressing a last time the button Fitlr. or Eco.
Start up of
Eco
function
After setting the function press
the key a second time to validate
Display of Eco
function
Press 5sec on
the Jets 1 key
Display of
accelerated
filtration
function
Display of
function
Press the + or –
key to set the
function
Press the + or –
key to set the
function
Start up of Filtration function
After setting the function press
the key a 2
nd
time in order to
validate
