24
Manuale Uso MP NIWA - Code 10011873 - Edition 1 - 03/2008
Instructions for operation
English
Unlocking the keyboard
Proceed as follows to remove the keyboard lock
(partial or total):
1) Press and hold down the
ECO
key. The
corresponding message will be displayed (
LocP
or
LocF
).
2) After two seconds, the “keyboard locked” icon
will begin to fl ash.
3)
After
fi ve seconds (without releasing the key),
the function is disactivated. The icon switches
off and
ULoc
is displayed for fi ve seconds.
Rotation of the Display
Using this function, the user can rotate the messages
shown on the display (with the exception of the
icons) by 180°, giving an “
upside-down
” eff ect.
To select this function, press and hold down the
LIGHT
key for fi ve seconds.
Repeat this procedure to restore the display to the
normal position.
At the momenty of switching on the appliance, this
function is not activated.
Rapid fi ltration (BOOST)
The “
BOOST
” function allows the user to select
the rapid fi ltration cycle. This is dvisable when the
mini-pool has been used intensively or in order to
dissolve the chemicals uniformly in the mini-pool
for the sanitization process.
To start this function, press and hold down the
ON/OFF
key for the two-speed pump for about
fi ve seconds.
The duration of this function is 45 minutes, during
which the following are switched on:
1) The ozonizer, the circulation pump and the
two-speed pump
2) For the “Niwa Wellness” model only, the
single-speed pump, too, will switch on once
for a period of 1 minute.
While the
BOOST
cycle is in operation, the heater
continues to operate normally.
When the function starts, the display shows “
boo
”
for the entire duration of the cycle.
If any of the massage functions is started by the user,
the
BOOST
cycle terminates immediately.
¡
Keyboard lock function
Operation of the keyboard can be locked in two
ways
1) Partial lock
allow the massage functions to be started
2)
Total
lock
none of the keys is operative
When either of the keyboard block functions has
been selected, the “keyboard locked” icon remains
lit.
Partial lock
The partial lock function is selected as follows:
- Press and hold down the
ECO
key.
After two seconds, the “keyboard locked” icon
begins to fl ash.
- After three seconds (still holding the key down),
the display shows
LocP
. The lock function is
now operative, and the “keyboard locked” icon
remains lit.
-
Release
the
ECO
key.
If one of the disabled keys is pressed, “LocP” is
displayed for 5 seconds.
N.B.
- In the event of a power failure, the partial lock
function is cancelled.
- If the partial lock function has been selected, it
must be disactivated before selecting the total
lock function.
Total lock
The total lock function is selected as follows:
- Press and hold down the
ECO
key.
After two seconds, the “keyboard locked” icon
begins to fl ash.
- After three seconds (still holding the key down),
the display shows
LocP.
The lock function is
now operative, and the “keyboard locked” icon
remains lit.
- Continue to hold down the
ECO
key.
-
After
fi ve seconds, the display shows LocF and
the function is operative.
- Release the key.
If any key is pressed when the total lock function has
been selected, “
LocF
” is displayed for 5 seconds.
N.B.
- In the event of a power failure, the partial lock
function is cancelled.
