5
Manuale Uso VS ACTPL-S/ACTPL-P - Code 10009717 - Edition 2 - 06/2007
Operating Instructions
English
Cleaning the Airpool valves
It may happen that the Airpool valves do not inject
air into the water. This may be caused by:
1) Obstruction of the valve by a build-up of
sediment.
2) Jamming of the ball inside the valve.
In either case, this problem is easily solved.
To remove the sediment and therefore restore
the correct movement of the ball inside the valve,
use the special tool supplied with the appliance
to grip the cover and remove the internal body
of the valve.
Wash the valve carefully and check that the
ball moves freely. Apply a layer of soap to the
valve body and replace by pressing gently into
position. Check that the rib is correctly inserted
into the groove.
Note that the valve cover is correctly positioned
when the two tabs beneath the edge are inserted
into their seats.
Cleaning the tub
The tub is built using materials which are easy
to clean and inhibit the build-up of bacteria on
the surface.
It is advisable to clean the tub regularly, preferably
using the speci
fi
c products available from our
authorized dealers and Service Centres.
If you prefer to use other products, the following
recommendations should be followed:
1) Always use a soft cloth; never use abrasive
cleaning products (pads etc.).
2) Never use powder detergents. Always use
good-quality liquid detergents which contain
no alcohol or ammonia.
3) Never use acetone, ammonia or products
containing these substances, as these can
seriously damage the tub. Similarly, never
use products containing formic acid or
formaldehyde.
4) Stubborn stains can be removed using
liquid detergent, silver polish or toothpaste
(depending on the type of stain) and rubbing
gently with a soft cloth.
5) To remove scale stains from the surface, use
lemon juice or vinegar (hot if possible) and
rub gently with a soft cloth.
Special maintenance
To keep the surface shine even after years of
use, apply a good-quality spray or wax polish
and rub with a soft cloth.
Light surface scratches or cigarette burns can
be removed using the special maintenance kit,
which is available from authorized dealers and
Service Centres.
If the damage to the surface is more serious, or if
damaged components require replacement, it is
necessary to contact a specialized technician.
The manufacturer recommends that users
contact the nearest authorized service centre
for all maintenance operations
.
Replacing the bulb in the underwater lamp
If the underwater lamp should malfunction, please
contact your local Service Centre.
10
3
4
1
2
No
No
fulgor 3002
s
teeril 100 tdf
tdf 80
decal
1000 m
l
e
td 68
+IT
di
RIPAR
AZIONEMANUT
ENZ
IONE
VASCHE
in
ME
TACR
ILAT
O
$OMI
NO
3P
!
6IA
6AL
CELL
INA
:ONA)
.OR
D
3P
ILIM
BER
GO
0OR
DENONE
)TA
LY
TEL
FAX
WWW
DOM
INOSPA
COM
