290 XF
102
Vinyl curtains should be stored either rolled or flat, without
folds or creases. Folding the curtains will make permanent
creases that could cause the vinyl to crack.
Note: Do not use any polish containing lemon scents or
lemon. The lemon juice will attack the vinyl and
shorten its life.
Snaps should be lubricated periodically with Teflon or silicone
grease. Zippers should be lubricated with silicone spray or
paraffin or a product designed to lubricate zippers in marine
canvas.
The bimini top, side curtains, clear connector, back drop
and aft curtain must be removed when trailering. Canvas
enclosures are not designed to withstand the extreme wind
pressure encountered while trailering and will be damaged.
Always remove and properly store the enclosure before
trailering your boat.
Do not operate engines, fuel consuming heaters or burners
with the canvas enclosures closed. The cockpit must be open
for legal ventilation and to prevent the possible accumulation
of carbon monoxide fumes, which could be lethal.
CARbON MONOXIDE IS A LETHAL, TOXIC GAS
THAT IS COLORLESS AND ODORLESS. IT IS A
DANGEROUS GAS THAT WILL CAUSE DEATH IN
CERTAIN LEVELS.
13.3 Cabin Interior
The cabin interior can be cleaned just like you would clean a
home interior. The wood floors and steps can be vacuumed
and cleaned with a mixture of water and Murphy’s Oil Soap.
Wipe the wood dry with a clean towel. To preserve the
cherry and teak woodwork, use furniture polish with wax. To
maintain the carpeting, use a vacuum cleaner.
Because air and sunlight are very good cleansers, periodically
put cushions, sleeping bags, etc. on deck, in the sun and fresh
air, to dry and air out. If cushions or equipment get wet with
saltwater, remove and use clean, fresh water to rinse off the
salt crystals. Salt retains moisture and will cause damage.
Dry thoroughly and reinstall.
Vinyl headliner material should be cleaned periodically as
explained in the previous section. Avoid using products
containing ammonia, bleach, or harsh chemicals as they can
shorten the life of vinyl.
If you leave the boat for a long period of time, put all cushions
on their sides, open all interior cabin and locker doors, and
hang a commercially available mildew protector in the cabin.
ALWAYS READ THE LAbEL CAREFULLY ON MILDEW
PROTECTORS. REMOVE THE PROTECTOR AND
ALLOW THE CAbIN TO VENTILATE COMPLETELY
bEFORE USING THE CAbIN.
Solid Counter Top Surfaces
A mild liquid detergent and water or ammonia-based cleaners
will remove most dirt and stains from the surface. For heavy
cleaning, oil, and grease, use Fantastik spray cleaner. Rinse
with a clean cloth moistened with fresh water. Wipe dry with
a clean cloth.
In most cases, solid surface counter tops can be repaired if
accidentally damaged. Minor damage, including scratches,
general or chemical stains, scorches or burns, and minor
impact marks, can be repaired with a light abrasive cleanser
and a Scotch-Brite
®
pad. For heavier damage, light sanding
and machine buffing may be necessary so contact your dealer
or a professional.
• Avoid exposing the counter tops to strong chemicals,
such as paint removers, oven cleaners, etc. If contact
occurs, quickly flush the surface with water.
• Remove nail polish with a non acetone‑based polish
remover and flush with water.
• Do not cut directly on counter tops.
13.4 Bilge and Engine Compartment
To keep the bilge clean and fresh, use a commercial bilge
cleaner regularly. Follow the directions carefully. The
engines and engine room should be kept clean and free of
oil accumulation and debris. All exposed pumps and metal
components, including the engines and drive gear, should be
sprayed periodically with a protector to reduce the corrosive
effects of the high humidity always present in these areas.
Maintenance intervals are outlined in the engine owner’s
manuals. Their recommendations should be followed
exactly.
Periodically check the bilge pumps for proper operation and
clean debris from the strainers and float switches. Inspect
all hoses, clamps and thru-hulls for leaks and tightness on a
regular basis and operate all thru-hull valves at least once a
month to keep them operating properly.
A flow of air into the bilge is provided by vents located in
the hull. Periodic inspection and cleaning of the ventilation
ducts is necessary to ensure adequate air circulation.
Summary of Contents for 290 EXPRESS FISHERMAN
