Albemarle 41 CONVERTIBLE Owner'S Manual Download

Page: 34 / 138

410 Convertible

Livewell

Located in the cockpit switch panel next to the ﬂybridge lad-
der.  Supplies 12-volt electrical current to the livewell pump
pressure  switch  located  on  the  pump.   The  pressure  switch
automatically  controls  the  water  pump  when  the  system  is
activated and properly primed.  It is protected by the circuit
breaker in the panel and an automatically resetting breaker on
the pump motor.

Baitwell (Optional)

Located in the cockpit switch panel next to the ﬂybridge lad-
der.  Supplies 12-volt electrical current directly to the baitwell
pump  pressure  switch  located  on  the  pump.    The  pressure
switch automatically controls the water pump when the system
is activated and properly primed.  It is protected by the circuit
breaker in the panel and an automatically resetting breaker on
the pump motor.

Lights

Located in the cockpit switch panel next to the ﬂybridge ladder.
Activates the lights that illuminate the cockpit area.

Cable Master Power Switch (Optional)

Located in the cockpit below the port gunnel near the ﬂybridge
ladder.  It controls the unit that extends and retracts the shore
power cord.  When the switch is in the “OUT” position, the
shore power cord will continue to extend until the switch is
turned off.  When the switch is in the “IN” position, the cord
will retract until the switch is turned off or the cord is com-
pletely retracted.   An  “In-Limit” switch built into the unit
automatically shuts the cable master off when the cable is fully
retracted.  The cable master is protected by a circuit breaker
in the cabin DC panel.

Holding Tank Macerator

The holding tank overboard discharge macerator switch panel
is located in the head compartment next to the holding tank
monitor.  It is a momentary switch that activates the overboard
macerator  discharge  system  for  the  holding  tank.    Refer  to
the  Marine  Head  System  in  the  Interior  Equipment  chapter
for additional information on the operation of the overboard
macerator discharge system.

Cabin DC Accessory Breaker Panel

Power is distributed to most of the 12-volt accessories through
individual circuit breakers located in two cabin DC breaker
panels.  The breaker panels are located  behind cabinet doors on
the port side of the cabin near the aft  bulkhead.  A main breaker
located near the house battery switch protects the system from
an overload.  Some 12-volt accessories are operated directly
by the circuit breaker in the panel while others are operated by
switches fed by the panel breakers.

A DC voltage meter is located in the lower panel that monitors
the voltage level in the batteries. It will monitor the voltage
of the batteries plus any electrical charges supplied to them

when the engines or the battery charger are operating. A se-
lector switch in the panel allows you to test each battery bank
individually.

A DC load meter is located in lower panel that indicates the
total amperage or current being drawn through the DC panel.
It is the total current level of all of the 12-volt equipment in
operation at the time.

The following is a description of the accessories controlled
by the breakers in the upper DC breaker panel:

12-Volt Main

Supplies the 12-volt current to the upper cabin DC breaker
panel and protects the panel from an overload.

Radar 1

Supplies electrical current directly to the optional radar unit.

GPS

Supplies electrical current directly to the GPS.

Spreader Lights

Supplies electrical current to the spreader light switch in the
helm switch panel.

Auto Pilot

Supplies electrical current directly to the auto pilot.

VHF 1