Albemarle 41 CONVERTIBLE Owner'S Manual Download

Page: 36 / 138

410 Convertible

Holding Tank Pump

Supplies electrical current to the macerator pump. This breaker
should be in the “OFF” position except when pumping out the
holding tank.

Horn

Supplies 12-volt electrical current to the horn switch in the
helm switch panel.

Blower

Supplies 12-volt electrical current to the bilge blower switch
in the helm switch panel. Refer to the blower switch in this
chapter and the Ventilation Systems chapter for more informa-
tion on the blower.

Bilge Lights

Supplies 12-volt electrical current to the bilge light switch for
the aft bilge compartment.

Trim Tabs

Supplies 12-volt electrical current to the trim tab switch on the
helm switch panel.

Head

Supplies electrical current directly to the vacuum pump on
the electric head system. A vacuum switch on the pump au-
tomatically controls the pump and maintains proper vacuum
in the system.

Bilge Lights

Supplies 12-volt electrical current to the bilge light switch for
the forward bilge compartment.

Baitwell

Supplies 12-volt electrical current directly to the livewell pump
pressure  switch  located  on  the  pump.   The  pressure  switch
automatically  controls  the  water  pump  when  the  system  is
activated and properly primed.  It is protected by the circuit
breaker in the panel and an automatically resetting breaker on
the pump motor.

Livewell

Stereo

Supplies 12-volt electrical current to the stereo.

Reserved

Reserved for additional DC equipment.

Cable Master

Supplies 12-volt electrical current to the optional Cable Master
control switch located in the cockpit. The Cable Master unit is
used to extend and retract the shore power cable.

Oil Change Pump

Supplies 12-volt electrical current to the switch on the oil
change pump.

Reserved

Reserved for additional DC equipment.

Electronics

Supplies 12-volt electrical current to the electronics.

Spare

Reserved for additional 12-volt equipment.

Spare

Reserved for additional 12-volt equipment.

Additional Breaker Panels:

The following is a description of the accessories controlled
by the “Push to Reset” DC breakers in the battery switch
panel:

Pt Engine Control Breaker

Provides protection and power for the 12-volt circuit to the
port engine electronic control processor. This “push to reset”
breaker is always supplied current when the port engine battery
switch is activated.

Stbd Engine Control Breaker

Provides protection and power for the 12-volt circuit to the
starboard engine electronic control processor. This “push to
reset” breaker is always supplied current when the starboard
engine battery switch is activated.

Batt Condition Starboard

Provides protection and power for the 12-volt circuit to the
battery condition test switch for the starboard engine battery
bank.

Batt Condition Port

Provides protection and power for the 12-volt circuit to the
battery condition test switch for the port engine battery bank.

Batt Condition House

Provides protection and power for the 12-volt circuit to the
battery condition test switch for the port engine battery bank.

Stereo

Provides protection and power for the stereo memory. This
“push to reset” breaker is always supplied current when the
batteries are connected.