15
9
Batteries
9.1
Functions and Display
All the e·motion’s displays necessary for operation are located
on the battery [2].
You receive information concerning the charge of the batteries
by pressing the button [10]. The battery’s charge is displayed
on the LED display [9]. You read the LED display as follows:
· 2 green active LEDs:
60 -100 % charge capacity
· 2orange active LEDs:
20 -60 % charge capacity
· Red LED active:
20 % charge capacity
· 1 red LED flashes:
< 10 % charge capacity
Red light on:
At this point, stop your e·motion immediately
and recharge the batteries!
· When 10 % or less charge capacity is reached, 4 signals
sound every minute.
9.2
Charging the Batteries
· Please exclusively use the
charger BCS2402A to charge
your batteries. The
charger is part of the standard
delivery package.
· Push the battery charger plug into the socket [8] on each
of the two rechargeable batteries [2].
A connection is made when the marking (red ring) on the
charging plug is covered completely by the systemunit and
no longer visible.
· For instructions concerning the charging capacity and the
times it takes to charge the batteries, please consult the
charger’s user’s manual.
Both batteries are fully charged, when the green
battery charger LEDs are active.
Depending on the selected level of power of the respective
wheels, the batteries may run low at different times.
Please also see chapter 7.1. Due to security reasons you
should always turn off both batteries (even if one of
them is not low yet) and recharge both at the same time.
Temperature must be above 10
°
C when charging the
batteries.
8
9
10
2
