Alberici HIRA 1, Operator'S Manual

9 

If the firmware of the machine includes the Pay-Out Table option, by which 

the amount of tokens delivered 

for different levels of POS paid money can be set, the display will allow the User to choose and purchase 
only among the preset payment levels.

See setting flow-chart in section 7.3.5.3 

DISPENSING MODE SETUP. 

Pay attention: Pay-out Table will work in Automatic Mode only! 

 WARNING: If there are not enough coins/tokens in the hopper to fulfil the whole payout request, the remaining 

credit shall be displayed and retained in memory. Switch off the machine, fill the hoppers, and switch on again: the 
remaining credit shall be paid out. 
An alternative option is to set the Remaining Credit Menu (see section 7.3.14) so as to cancel the remaining credit - 
and at the same time record it in the Accounts menu - by switching the machine off and on again. 

6.3

 RECHARGE OF CARD / KEY

When equipped with the ACS Card/Key reader (see 7.3.5.3), the Money Changer can operate as 
recharger of credit for User Card/Keys. These can then be used to purchase services or goods from 
nearby self-service dispensers or distributor kiosks, provided that the ACS readers in such kiosks 
have been initialized with the same PIN as the one in the Change Machine. When the User 
Card/Key is in the Hira ACS reader, and money is introduced, the display will prompt for pressing 
any green-lit button to load the credit onto the Card/Key. 

6.4

OPERATIONS WITH RFID CARD/KEYS

If the machine is equipped with the ACS Reader for the RFID Cards/Keys, it is possible to use 
such Card/Keys to perform useful functions, according to which type of Card/Key is inserted. 

6.4.1

Operation with User Card/Key 

When inserting a compatible RFID User Card/Key (must be  
initialized with the same password as the RFID reader - see  
section 

7.3.5.3 S

ET 

U

P 

C

ASHLESS

), the available credit gets  

shown, and a pushbutton will light up and flash green. 

If more credit must be loaded, insert more coins and/or notes  
until the desired value is attained, then wait until the storing  
message (“Data are being stored”) disappears, then remove  
the Card/Key loaded with new credit. The Card/Key can now  
be used to buy services or products from machines equipped  
with ACS reader, provided that also such ACS readers have  
been initialized with the same password as the RFID reader of the change machine. 

6.4.2

Operation with Service or Master (see also section 7.3.5.3) 

Insert the Service Card/Key (white) or the Master Card/Key (black) in the ACS reader to get 
access to the Service Menu (without the need to open the machine and get access to the money). 
The Service menu allows to: 1) initialize the User Card/Keys, as well as to 2) check the Accounts 
Data. By the Service Card/Key, the operator can reset the Partial Accounts. By the Master 
Card/Key, the operator can reset all Accounts data and can also   - if the machine is connected to 
the printer -   print out the Account records (see menu steps next page). 

Press green button 

to load credit

Available Credit: 

NN,nn