16
LEVEL 4:
By “OK”, confirm LEV5.
By “+”, set Level 4 to 2,00€ and confirm. HP1 will automatically set to 2 pieces (2 x 1€).
You can set the pay-out table so as dispense any of the following combinations: (A) 2x1€
coins, or (B) 1x1€ + 10x0,10€ coins, or else (C) 20x0,10€ coins.
Suppose choosing the combination (C): by the “-” button, change HP1 to 1 (1x1€ coins)
and press OK. By the “+” button, set HP2 to 10 (10x0,10€)
Confirm until <LEV 4 HP1 HP2> shows again.
PRESS “+” FOR LEVEL 5 (PRESS REPEATEDLY “+” TO EXIT).
LEVEL 5:
By “OK”, confirm LEV4.
By “+”, set Level 5 to 5,00€ and confirm. HP1 will automatically set to 5 pieces (5 x 1€).
You can set the pay-out table so as dispense any of the following combinations: (A) 5x1€
coins, or (B) 1x1€ + 40x0,10€ coins, or (C) 2x1€ + 30x0,10€ coins, or (E) 3x1 + 20x0,10€
coins, or (F) 4x1 + 10x0,10€ coins, or else (G) 50x0,10€.
Suppose choosing the combination (F): by the “-” button, change HP1 to 4 and press OK;
by the “+” button, set HP2 to 10 (10x0,10€)
Confirm until <LEV 5 HP1 HP2> shows again.
PRESS “+” FOR LEVEL 6 (PRESS REPEATEDLY “+” TO EXIT).
LEVEL 6:
By “OK”, confirm LEV6.
By “+”, set Level 6 to 10,00€ and confirm. HP1 will automatically set to 10 pieces (10 x 1€).
You can set the pay-out table so as dispense any of the following combinations: (A) 10x1€
coins, or (B) 9x1€ + 10x0,10€ coins, or (C) 8x1€ + 20x0,10€ coins, or ….. (N) 5x1 +
50x0,10€ coins, and so on.
Suppose choosing the combination (B): by the “-” button, change HP1 to 9 and press OK; by
the “+” button, set HP2 to 10 (10x0,10€).
Confirm until <LEV 6 HP1 HP2> shows again.
PRESS “+” FOR LEVEL 7 (PRESS REPEATEDLY “+” TO EXIT).
LEVEL 7:
By “OK”, confirm LEV7.
By “+”, set Level 7 to 20,00€ and confirm.
You can set the pay-out table so as dispense any of the following combinations: (A) 20x1€
coins, or (B) 19x1€ + 10x0,10€ coins, or (C) 18x1€ + 20x0,10€ coins, or … (M) 16x1€ +
40x0,10€, or ... (N) 5x1 + 50x0,10€, and so on. Suppose choosing the combination (M): by
the “-” button, change HP1 to 16 and press OK; by the “+” button, set HP2 to 40
(40x0,10€).
Confirm until <LEV 7 HP1 HP2> shows again.
PRESS “+” FOR LEVEL 8, OR PRESS OK UNTIL EXITING.
NOTICE: monitoring of level sensors is disabled by default. This means that the board
does not know when the hopper is empty, so it will send the pay-out command even if there
are no coins available. When the hopper runs out of coins during dispensing or at the end
of payment, no warning will be displayed. If the empty state is detected when powering the
unit, this one shall not accept any money.
If instead the monitoring has been enabled, and there are not enough coins in the hopper,
the display will warn that the hopper is empty. There will usually remain 20 coins
approximately, so as to complete the change payout.
PLEASE PAY ATTENTION: if the machine must be re-configured from token (or
token + return change) dispenser to coin changer, always do reset to DEFAULT
CONFIGURATION and RESET ACCOUNTS. Else, the bonus setting could produce
Accounts inconsistency.
