Manuale istruzioni
-FKC 65 UB
01/01/19 Rev: 1.0.0
20
6.
MACHINE TRANSPORT AND LIFTING
Lift the brush plate before proceeding with transport. Place the machine on a pallet, taking
care to lock the wheels to prevent the machine from moving.
Transport and any lifting must be done with the machine on a pallet.
It is recommended to empty the solution recovery tanks.
If the rubber-dryer
FKC65 UB
is loaded on a vehicle, with ramp, or in any case every
time it is required to drive it on a steep ramp, it is recommended to lift the brush plate and
take down the splash-guards and brushes.
7.
INTENDED USE OF THE MACHINE (washing and drying
phase)
FKC 65 UB
is a Scrubber-Dryer machine, driven by an operator seated on board, to
wash and dry hard floors, battery powered, intended for commercial use.
The machinery applies a detergent solution to the hard floor, a solution that is collected
in the solution tank and is conveyed through suitable piping to the brush plate, with
solenoid valve adjustable flow, it scrubs the floor by the combined action of two counter-
rotating brushes and then draws the dirty water into the recovery tank.
It is also possible to spray the floor with water, actuating the brushes only for scrubbing
and cleaning, without drying.
Finally, when a floor is already wet, it might be required to permanently lift the brush
plate without actuating its rotation and pass with activated suction only, in order to suck
the water from the floor and draw it into the recovery tank .
Other operations are not intended for the
FKC 65 UB
.
Any other operation should therefore be considered as improper.
Summary of Contents for FKC 65 UB
