Manuale istruzioni
-FKC 65 UB
01/01/19 Rev: 1.0.0
31
13.3. EMPTYING AND CLEANING THE SOLUTION TANK
1. Place the vehicle near a floor drain. The discharge pipe is in the left front corner of the
machine, under the tank.
2. Turn the ignition key to “OFF”, the parking brake is engaged.
3. Remove the clip from the small discharge pipe connected to the solution tank.
The pipe is underneath the machine, on the left side. Lower the pipe towards the drain,
turn on the cock.
4. Wash the tank with clean water and run clean water into the system, until reaching tank
capacity (80 litres). Do not use water at temperature higher than 50º to clean the tank as
it might be damaged.
NOTE: Never leave the solution inside the tank as it might damage the tank, the seal
gaskets and the solenoid valves.
6. Replace the discharge pipe.
Summary of Contents for FKC 65 UB
