Manuale istruzioni
-FKC 65 UB
01/01/19 Rev: 1.0.0
43
15.2 CHARGING THE BATTERIES
1. Place the machine in a clean and well-ventilated area, near a battery charger.
2. Lift the upper tank to access the battery compartment.
FOR SAFETY
Before leaving the machine unattended or performing any maintenance operation, ensure
it is on a flat surface, engage the parking brake, turn off the machine and remove the key.
3. Tilt the upper tank, after ensuring it does not contain any water.
4. Check electrolyte level in every battery element. Before charging the battery, add a
sufficient amount of water to cover the plates. After completing recharge, add a sufficient
amount of water to bring the water level to the gauge level. If the water level is too high
before charging, the normal electrolyte expansion may cause it to leak which causes loss
of acid balancing and machine damage.
5. Replace battery caps.
6. Disconnect the battery connector form the machine. Disconnect the battery charger
form the power outlet.
FOR SAFETY
When charging the batteries, connect the battery charger to the batteries before connecting
it to the power outlet. Never connect the battery charger to the power outlet first as sparks
might be generated.
7. To charge the battery pack, use a DC 24 V battery charger that
Automatically switches off as soon as the batteries are completely charged.
8. Connect the battery charger to the battery connector. Connect the battery charger cable
to the power outlet. The charge indicator shows that the batteries are under charge.
9. When the batteries are completely charged, disconnect the battery charger from the
batteries.
10. Connect the batteries to the machine connector.
11. Check electrolyte level. The level must reach the gauge. If necessary, add distilled
water.
12. Lower the upper recovery tank into its position.
15.3 BRUSH PLATE ADJUSTMENT
FKC 65 UB
The brush plate is pre-shaped for optimal adherence to the floor. There is
the option of adjusting the brush plate pressure on the ground, to have a more or less
effective scrubbing action. Use the panel button to do that.
The switch controls the pressure exerted on the floor by the brushes. To decrease pressure,
press the top of the switch. To increase the pressure, press the bottom part of the switch
and check the led display that indicates the pressure exerted by the brushes on the floor.
Summary of Contents for FKC 65 UB
