14
Initializing the Scanner
Caution: This procedure clears all information you stored in the scanner’s memory.
Initialize the scanner only when you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again.
2. Press and hold CL/DELAY.
3. While holding down CL/DELAY, insert a pointed object, such as a straightened
paper clip, into the reset opening at the back of the scanner and gently press then
release the reset button inside the opening.
4. When the display reappears, release CL/DELAY.
Note: You must release RESET before releasing CL/DELAY, otherwise the memory
might not clear.
SEARCHING FOR AND STORING ACTIVE FREQUENCIES
You can store frequencies into channels using any of the following methods:
l
Manual storage
l
Auto storage
l
Each search operation
l
Tuning Operation
l
Moving a frequency from a monitor memory
Manually Storing Frequencies
If you know a frequency you want to store, you can store it manually.
1. Press PGM. PGM appears.
2. To select the channel where you want to store the frequency, use the number keys
to enter the channel number, then press PGM.
3. Using the number keys, enter the frequency you want to store into that channel.
