23
TURNING CHANNEL-STORAGE BANKS OFF AND ON
To turn off banks while scanning, press the bank's number key until the bar under the
bank's number disappears. The scanner does not scan any of the channels within the
banks you have turned off.
Notes:
l
You cannot turn off all banks. There must be at least one active bank.
l
You can manually select any channel in a bank, even if the bank is turned off.
To turn on banks while scanning, press the bank's number key until a bar appears
under the bank's number.
MOVING FREQUENCIES
Moving a Frequency from a Monitor Memory to a Channel
1. Press PGM.
2. Use the number keys to enter the channel number where you want to store the
monitor frequency, then press PGM.
3. Press MON. MON flashes. Use the number keys to enter the monitor memory's
number (1-50), then press MON.
MON flashes and the monitor memory's number and frequency appear.
4. Press ENTER. The scanner stores the frequency in the selected channel.
5. To move another monitor memory frequency to the next channel, press PGM and
repeat Steps 3 and 4.
Moving Frequencies from Monitor Memories to a Bank
Your scanner can move all the frequencies you have stored in monitor memories into
a bank you specify.
Notes:
l
If there are more frequencies in the monitor memories than there are empty
channels in the bank you select, the scanner moves only as many frequencies
from the monitor memories as it has room for in the bank, leaving the remaining
frequencies in the monitor memories.
l
The scanner programs monitor memory frequencies into channels even if the
same frequencies are already programmed into other channels.
