4
22
959-960
23
1240-1300
The use of this scanner is only authorised if the person concerned complies with all
the provisions which apply within the country in which the scanner is used. You are
advised to satisfy yourself that you are aware of the various restrictions which might
apply within a particular country. At no time will your supplier be liable for the unlawful
use of a scanner.
PREPARATION
This scanner is primarily designed for use in the home as a base station. You can
place it on a desk, shelf, or table.
Your scanner’s front feet fold up or down. Adjust them to give you the best view of
the display.
HOW TO AFFIX THE AERIAL SUPPLYED WITH THE SCANNER
Screw the telescopic aerial supplied into the hole situated in the top right-hand corner
of the scanner.
The length of the aerial will affect the quality of the reception achieved by the
scanner. For maximum reception, use the aerial as follows:
25-300 MHz: aerial should be fully extended
300-520 MHz: three sections of the aerial should be pulled out.
520-1300 MHz: aerial should be collapse all segments
CONNECTING THE SCANNER TO AN OUTSIDE AERIAL (OPTIONAL)
The telescopic aerial provided will normally be perfectly adequate for the purpose of
receiving strong, local signals. In order to receive the weaker signals also, an outside
aerial may be connected to the aerial connector situated at the rear of the AE100T.
For this purpose, use a special scanner aerial – your supplier will be able to provide
you with further information on this subject.
Place the outside aerial on as high a location as possible, and assemble it in
accordance with the instructions provided. To link the aerial to the scanner, use a
