16
frequency and CTCSS frequency must be matched. The frequency charts at the end of this
manual are included to help with this selection. In general, most PMR446 radios use the
same 8 channels and many brands allow CTCSS subcode operation with the same standard
CTCSS code numbers 01 –38.
Monitor button
Pressing and holding the
MON
button lets you hear white noise so you can adjust the volume
level of the radio level when not receiving a signal. The
MON
should be used to check
activity on current channel before transmitting, and in cases where the connection to another
station becomes weak and interrupted.
Time out Timer
The Time-out Timer (TOT) feature helps extend battery life by preventing accidental
continuous transmission. The radio will emit a warning tone if the PTT button is pressed
continuously for 60 seconds and the radio will stop transmitting.
Power Selection
Your radio has two transmit power levels, 500 mW and appr. 50 mW. To select the power
levels:
•
Press
MENU
until the
P.HIGH
or
P.LOW
icon flashes.
•
Press
UP
or
DOWN
to select between high and low power levels.
•
Press the
PTT
button for save and exit.
Note
: Please use low power wherever it is possible. Transmitting with Hi Power will result in
much higher power consumption and will drain Your batteries much faster compared to low
power position. In many situations, where the communication distance is not so long, it is
more than enough to use the LOW power position (50 mW)
Keypad Lock
To avoid accidentally changing radio operation, press
MENU
for minimum 3 seconds. The
icon will be appear. When
is on, the menu functions and
UP
/
DOWN
buttons are
disabled. When locked, you will be able to turn the radio off and on, increase or decrease
volume, monitor, transmit and send a call tone. To unlock, press
MENU
again for at least 3
seconds.
Call Tone
Your PMR radio has 10 different call tones available. To select the call tone:
•
With the radio on, repeatedly press
MENU
until
CALL
appears. The current call tone
number setting will begin to flash.
•
Press
UP
or
DOWN
to change the call tone. The new call tone will be heard over the
speaker.
•
Press
MENU
or the PTT button to save the new call tone and exit the menus.
Note
: Setting the call tone to 0 disables the call tone function.
Roger Beep Tone
Whenever you release the PTT button, a “Roger Beep” tone may be transmitted to let your
friends know you are finished talking. To enable the Roger Beep, turn the radio off. Press
and hold
UP
as you turn your radio on. The
icon will appear in the upper right position of
the display. Repeat the same steps to turn off the Roger Beep.
Summary of Contents for Tectalk Action
