36
12
) RF Frequency: Adjust it at range of 30 to 999 MHz. Set it according your regional
situation or inquire your local services.
13
) RF Level: Adjust it at range of -16~ -36dBm.
14
) RF On: User can choose to turn on or turn off the RF under this menu.
15
) Bit Rate: User can read the current modulating bit rate and the maximum bit rate
16
) TSID: (Transport Stream ID) User can view or adjust after enter this menu.
17
) ONID: (Original Network ID)-User can view or adjust after enter this menu.
18
) NIT: (Network Information Table) NIT table is a very important table for describing the
network and TS. User can enter the submenus displayed and edit the values or select the
LCN (Logical channel number) mode, and choose whether to insert the NIT. If user chooses
to insert the NIT, information (Network ID, Network Name, LCN Mode, Private Data and
LCN number of the program mentioned in explanation 6) will be added to the transport
stream.
¾
NOTE
: when the Private Data is set as 0*0, it is invalid.
19
) VCT: Virtual Channel Table. This menu contains two sub-menus, Modulation Mode and
VCT Insert. User can edit modulation mode at the range of 0-255.
20
) EIT: EIT Insert - As mentioned above (6), the event information table can be chosen
whether to insert into the TS or not under this menu. If yes, the EIT information set above (6)
will be displayed on the TV screen. Language Code – to set the EIT language For example,
code of the English language is
eng
. If you set the code as
eng
, the EIT displayed will be in
English language.
21) – 25)
Please refer to
Chapter 5
for details.
26
) Save Config:
Yes/No
-to save/give up the adjustment of setting.
27
) Load Saved CFG:
Yes/No
-to load/ not to load the saved configuration.
28
) Reset all sets:
Yes/No
-choose/not choose the factory’s default configuration.
29
) LCD Time out: A time limit that LCD will light off. Choose among 5s, 10s, 45s, 60s, 90s
and 120s (seconds).
30
) Key Password: User can set a 6-digital password used to unlock the keyboard.
31
) Lock Keyboard: Choose
Yes
to lock the keyboard, then the keyboard cannot be
applicable. It is required to input the password to unlock the key board. This operation is
Summary of Contents for DMH-141
