Preparation and test of the main unit
Overview
This section describes the preparation and test of a 1645 AMC main unit.
Estimated duration
15 minutes
Procedure
Proceed as follows to perform the main unit test:
...................................................................................................................................................................................................
1
Connect the ITM-CIT to the E.
...................................................................................................................................................................................................
2
Create the node. If available, use the operator specified name of the E.
...................................................................................................................................................................................................
3
Provision the DC parameter Area ID; set it to the operator specified value.
ote:
If the Area Address is not available then we suggest leaving the unit isolated
until the value is available. The reason for this is that value 0000 is reserved for newly
installed units and should not be used in live networks. An E in the isolated state if
the OSI protocol has not been activated. Getting the E out of the isolated state is
done by editing the area address.
...................................................................................................................................................................................................
4
Verify that the requirements mentioned in the table below are met:
Result:
Requirements
ode isolated:
o
LEDs on the 1645 AMC :
Power:
On
Fault:
Off
E
N D
O F
S T E P S
...................................................................................................................................................................................................
Stand-alone test procedures
Preparation and test of the main unit
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
7-4
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
365-313-103R8.0
Issue 2
July 2009